How to Enable Custom OSD on DJI Goggles V2

I. Principle

The V2 goggles support custom OSD (On-Screen Display), but this feature must be enabled after switching to the DJI Digital FPV System mode. Once enabled, flight data such as voltage, RSSI, and flight mode can be displayed on the screen, enhancing the FPV experience.

II. Equipment Preparation

FPV Goggles: DJI FPV Goggles V2
FPV Video Transmitter: DJI AIR UNIT / Caddx Vista (compatible with DJI Digital FPV System)

III. Procedure

Step 1: Switch to DJI Digital FPV System

1. Open the V2 goggles and ensure the device has started normally.
2. Use the joystick to enter the Settings menu.
3. In System Settings, select DJI Digital FPV System.
   
4. Confirm the switch and restart the device to complete the mode conversion.

Step 2: Enable Custom OSD

1. Enter the V2 goggles' settings menu and find the "Display" option.
   
2. On the Display Settings page, find the "Custom OSD" option.
   
3. Select and enable "Custom OSD".
   

Step 3: Configure Flight Controller Parameters

Important

For information on how to set various HD video transmitter parameters in ArduPilot firmware, refer to this link: https://docs.corewing.com/plane/ardupilot/settings/vtx/hd-vtx/config.html

SpeedyBee F405 WING APP/MINI:

CoreWing F405 WING V2:

IV. Q&A

Q: What if I cannot find the "Custom OSD" option?
A:

• Ensure you have switched to the DJI Digital FPV System; this option will not appear in other modes.
• Try restarting the V2 goggles; in some cases, settings changes require a restart to take effect.
• Ensure the goggles firmware is the latest version; some older firmware versions may lack this feature.

Q: After enabling custom OSD, why is the OSD still not displaying?
A:

• Enter the flight controller software (INAV) and ensure OSD data output is enabled.
• Check the connection between the flight controller and the VTX to ensure it is correct, and ensure OSD serial output is enabled.
• Try resetting OSD settings, re-selecting, and enabling the required OSD elements.

Q: How to customize OSD display content?
A:

• In the INAV configurator OSD tab, select the information to be displayed (battery voltage, RSSI, flight mode, etc.).
• Adjust the OSD element positions to make the information clearer.
• Save the settings and restart the device to confirm the OSD changes take effect.

Technical Support QR Code